Lane Positions:

return to top

In some ways the size of the motorcycle can work to your advantage. Each traffic lane gives a motorcycle three paths of travel, as indicated in the illustration.

Your lane position should:

• Increase your ability to see and be seen.
  
  
• Avoid other's blind spots.
  
  
• Avoid surface hazards.
  
  
• Protect your lane from other drivers.
  
  
• Communicate your intentions.
  
  
• Avoid wind blast from other vehicles.
  
  
• Provide an escape route.

Select the appropriate path to maximize your space cushion and make yourself more easily seen by others on the road.

In general, there is no single best position for riders to be seen and to maintain a space cushion around the motorcycle. No portion of the lane need be avoided - including the center.

Position yourself in the portion of the lane where you are most likely to be seen and you can maintain a space cushion around you. Change position as traffic situations change. Ride in path 2 or 3 if vehicles and other potential problems are on your left only. Remain in path 1 or 2 if hazards are on your right only. If vehicles are being operated on both sides of you, the center of the lane, path 2, is usually your best option.

The oily strip in the center portion that collects drippings from cars is usually no more than two feet wide. Unless the road is wet, the average center strip permits adequate traction to ride on safely. You can operate to the left or right of the grease strip and still be within the center portion of the traffic lane. Avoid riding on big buildups of oil and grease usually found at busy intersections or toll booths.

Following Another Vehicle:

return to top

"Following too closely" could be a factor in crashes involving motorcyclists. In traffic, motorcycles need as much distance to stop as cars. Normally, a minimum of two seconds distance should be maintained behind the vehicle ahead.

To gauge your following distance:

• Pick out a marker, such as a pavement marking or lamppost, on or near the road ahead.
  
  
• When the rear bumper of the vehicle ahead passes the marker, count off the seconds:"one-thousand-one, one-thousand-two."
  
  
• If you reach the marker before you reach "two", you are following too closely.

A two-second following distance leaves a minimum amount of space to stop or swerve if the driver ahead stops suddenly. It also permits a better view of potholes and other hazards in the road.

A larger cushion of space is needed if your motorcycle will take longer than normal to stop. If the pavement is slippery, if you cannot see through the vehicle ahead, or if traffic is heavy and someone may squeeze in front of you, open up a three-second or more following distance.

Keep well behind the vehicle ahead even when you are stopped. This will make it easier to get out of the way if someone bears down on you from behind. It will also give you a cushion of space if the vehicle ahead starts to back up for some reason.

When behind a car, ride where the driver can see you in the rearview mirror. Riding in the center portion of the lane should put your image in the middle of the rearview mirror - where a driver is most likely to see you.

Riding at the far side of a lane may permit a driver to see you in a sideview mirror. But remember that most drivers don't look at their sideview mirrors nearly as often as they check the rearview mirror. If the traffic situation allows, the center portion of the lane is the best place for you to be seen by the drivers ahead and to prevent lane sharing by others.

Being Followed:

return to top

Speeding up to lose someone following too closely only ends up with someone tailgating you at a higher speed.

A better way to handle tailgaters is to get them in front of you. When someone is following too closely, change lanes and let them pass. If you can't do this, slow down and open up extra space ahead of you to allow room for both you and the tailgater to stop. This will also encourage them to pass. If they don't pass, you will have given yourself and the tailgater more time and space to react in case an emergency does develop ahead.

Passing and Being Passed:

return to top

Passing and being passed by another vehicle is not much different than with a car. However, visibility is more critical. Be sure other drivers see you, and that you see potential hazards.

   

Passing:

Ride in the left portion of the lane at a safe following distance to increase your line of sight and make you more visible. Signal and check for oncoming traffic. Use your mirrors and turn your head to look for traffic behind. When safe, move into the left lane and accelerate. Select a lane position that doesn't crowd the car you are passing and provides space to avoid hazards in your lane. Ride through the blind spot as quickly as possible. Signal again, and complete mirror and headchecks before returning to your original lane and then cancel the signal. Remember, passes must be completed within posted speed limits, and only when permitted. Know your signs and road markings!

Being Passed:

When you are being passed from behind or by an oncoming vehicle, stay in the center portion of your lane. Riding any closer to then could put you in a hazardous situation. Avoid being hit by: The other vehicle - A slight mistake by you or the passing driver could cause a sideswipe. Extended mirrors - Some drivers forget that their mirrors hang out farther than their fenders. Objects thrown from windows - Even if the driver knows you're there, a passenger may not see you and might toss something on you or the road ahead of you. Blasts of wind from larger vehicles - They can affect your control. You have more room for error if you are in the middle portion when hit by this blast than if you are on either side of the lane. Do not move into the portion of the lane farthest from the passing vehicle. It might invite the other driver to cut back into your lane too early.

Lane Sharing:

return to top

Cars and motorcycles need a full lane to operate safely. Lane sharing is usually prohibited.

Riding between rows of stopped or moving vehicles in the same lane can leave you vulnerable to the unexpected. A hand could come out of an window; a door could open; a car could turn suddenly. Discourage lane sharing by others. Keep a center-portion position whenever drivers might be tempted to squeeze by you. Drivers are most tempted to do this:

• In heavy, bumper-to-bumper traffic.
  
  
• When they want to pass you.
  
  
• When you are preparing to turn at an intersection.
  
  
• When you are getting in an exit lane, or leaving a highway.

Merging Cars:

return to top

Drivers on an entrance ramp may not see you on the highway. Give them plenty of room. Change to another lane if one is open. If there is no room for a lane change, adjust speed to open up space for the merging driver.

Cars Alongside:

return to top

Do not ride next to cars or trucks in other lanes if you do not have to. You might be in the blind spot of a car in the next lane, which could switch into your lane without warning. Cars in the next lane also block your escape if you come upon danger in your own lane. Speed up or drop back to find a place clear of traffic on both sides.