Instruction for part four Chain and Alignment Commands

It is important that the information be read. The exercises in the part are based on the information that it contains.

WRITE OUT ALL SYNTAX LINES begin sheet 44

  1. All problems are to be answered by writing out the lines of syntax. You are not to use the machine GEOPAK.
  2. The exercise for chain and alignments require that you write line(s) of syntax for stored points before you write the syntax lines

Two (2) OPEN alignment exercise sheet 50

Two (2) INCOMPLETE alignment exercises sheet 57

One (1) INVERSE alignment exercise sheet

Final exercise is to write a complete alignment input file for line Y40, sheet 63.

Feel free to any syntax line you have learned

3. A special note should be take of sheets 11 & 31 intrinsic values

 

Your written solutions can be mailed or faxed to Mary Sue Aldridge or Glenn Plott in Roadway Design CADD Support for evaluation. Your solutions will be evaluated and return to you with suggestions for correcting any mistakes if any. You will then be advised to go to the next unit.

FOR QUESTIONS (919) 250 4016 EXT 218 for Mary, or 313 for Glenn

Mary Sue Aldridge/Glenn Plott

Roadway Design Unit

P O Box 25201

Raleigh, NC 27611

Fax (919) 250-4036

Courier # 51 31 00